Euro Pro Carpet Cleaner SC710 S User Manual

OWNER’S MANUAL  
Model SC710 S  
120V., 60Hz., 1000 Watts  
For information or assistance:  
EURO-PRO Operating LLC  
94 Main Mill Street, Door 16.  
Plattsburgh, NY 12901  
Tel: 1 866 98SHARK (1 866 987-4275)  
 
USAGE SUGGESTIONS FOR YOUR SUPER STEAMER  
ADDITIONAL IMPORTANT SAFEGUARDS cont.  
1. To avoid circuit overload, do not operate another appliance on the same socket (circuit)  
2. If an extension cord is absolutely necessary, a 15 ampere 14 gage cord should be used.  
Cords rated for less amperage may overheat. Care should be taken to arrange cord so  
that it cannot be pulled or tripped over.  
CAUTION: This appliance must be unplugged from the electrical outlet  
and allowed to cool down before all cleaning and maintenance tasks.  
Let the appliance cool down completely before cleaning or storing.  
Empty all water from the water tank after each use.  
Store in a dry, cool place.  
3. Do not leave unattended when the system is connected to a power supply/electrical outlet.  
SAVE THESE INSTRUCTIONS  
A periodic rinse of your steam cleaner will free it from deposits. This is  
recommended every 10-15 tankfulls to free up any scale deposits. Fill the boiler  
with water and shake vigorously. Tilt the cleaner upside down to empty the boiler of  
water and any scale deposits.  
FOR HOUSEHOLD USE ONLY  
Cleaning the Nozzles:  
WARNING: This appliance is equipped with a  
grounded-type 3-wire cord (3-prong plug). This  
plug will only fit into an electrical outlet made for a  
3-prong plug. This is a safety feature. If the plug should  
fail to fit the outlet, contact an electrician to replace the  
obsolete outlet. Do not attempt to defeat the safety  
purpose of the grounding pin, part of the 3-prong plug.  
Your steamer should not normally require cleaning, however, should you notice a  
marked decrease in steam output it may be necessary to remove mineral deposit  
build-up from the nozzle orifice. First ensure that there is water in the tank. If tank is  
empty, fill with water, (we recommend using purified or demineralized water), then re-  
start unit noting whether steam output is normal. If steam output is still low, follow  
these cleaning instructions:  
1.  
2.  
Unplug steam cleaner from wall outlet.  
Use a small diameter stiff metal wire such as a straightened metal  
paperclip and carefully insert the end of the wire into the nozzle orifice. See  
illustration below.  
3.  
4.  
5.  
Move wire back and forth several times to remove any deposits.  
Reconnect appliance to power outlet, switch on and note steam output.  
If steam performance does not improve, repeat steps #1 through #4.  
2
9
 
GETTING TO KNOW YOUR SHARK SUPER STEAMER  
USAGE SUGGESTIONS FOR YOUR SUPER STEAMER  
Upholstery  
Use the steam diffuser with the cleaning cloth. Use fast, light strokes, avoid getting  
the fabric wet. Be patient with stubborn spots; work on a spot gently for no more than  
a minute at a time, then wait five minutes for the area to dry and repeat. Use circular  
movements or back-and-forth and side-to-side movements to get all sides of surface  
fibers. Finish with a brushing in one direction that will give the fabric a uniform  
appearance.  
CAUTION: Always determine the color-fastness of any fabric - especially  
with reds or blues - by taking a clean, moist, warm towel and gently rubbing a  
small area as far down on the back or other out of the way place on the  
furniture as possible. If color comes off on the towel, you may need to have  
the piece dry cleaned.  
Window, Glass Surfaces and Mirrors  
To use the window squeegee, work with the vapor jet down using the top to bottom  
movements. To do this without leaving streaks, use lateral movements from the top  
to the bottom of the surface.  
CAUTION: When cleaning outside windows, always avoid any sudden  
changes in temperature to prevent breakage or cracks.  
Soap Scum  
Soap scum dissolves almost immediately under a combination of heat and moisture.  
Rinse the surface with a small amount of water afterwards or go back over it once  
more with a clean terry cloth towel.  
Notes: Soap scum sometimes will develop a hard surface from waterborne  
minerals. If this is the case, use the small detail brush first to break up this surface -  
or spray or wipe first with lemon, vinegar or seltzer soda water to soften the  
minerals.  
Accessories  
Measuring Cup  
Funnel  
Moving too slowly can dry out the soap scum and cause it to granulate on the  
surface. The surface will have a gritty feel. If this happens, apply vapor to the  
surface with the small detail brush again and re-clean.  
Unit Parts  
Main Unit  
Handle  
Trigger Button  
Filler Hole  
Safety Cap  
Indicator Light  
Power Cord  
8.  
9.  
1.  
2.  
3.  
4.  
5.  
6.  
7.  
10. Steam diffuser  
11. Cleaning Cloth  
12. Concentrator Nozzle  
13. Window Squeegee  
14. Small Detail Brush  
15. Angle Adapter  
16. Hose  
Bathroom Areas  
To clean the bathtub or shower area, use the small detail brush for grout, shower  
door tracks, hard to get areas and heavily soiled areas. Allow plenty of time for the  
heat to penetrate the surface. This is especially helpful in the shower area if there is  
tile or grout.  
To clean the toilet, use small detail brush. Use a terry cloth towel or paper towel to  
wipe up excess moisture and residue.  
Technical Specifications  
Voltage:  
120V., 60Hz.  
To clean the sink and faucets, use small detail brush.  
Power:  
Water Capacity:  
1000 Watts  
9 Oz.  
8
3
 
OPERATING INSTRUCTIONS  
FEATURES  
The SHARK SUPER STEAMER utilizes pressurized steam to remove tough  
grease,dirt and grime. Steam is nature’s purest and most powerful cleaner for safely cleaning  
all hard surfaces in your home without harsh chemicals, thus being perfectly ecological. The  
appliance has various attachments so that it can be used for many purposes such as:  
Small Detail Brush / Angle Adapter  
Both the angle adapter and the small detail brush can be used on the concentrator  
nozzle.  
If using with the concentrator nozzle, push the attachment onto the end of the nozzle.  
1. Clean upholstery, sealed grout, bathroom/kitchen tile, stovetops.  
2. Easy to clean difficult to reach areas with the angle adapter or concentrator such as  
faucets, etc.  
3. Ideal for windows, mirrors, glass doors, etc.  
4. Clean fabrics, window coverings, pillows, bedding etc.  
5. Clean hard surface areas such as counters, sinks, shower door tracks, etc.  
WARNING: The SHARK SUPER STEAMER is designed to clean  
hard surfaces and upholstery that will withstand high heat. Do not use on  
soft plastics,unsealed wood and cold glass. On surfaces that have been  
treated with wax or some no wax floors, the sheen may be removed by the  
heat and steam action. Do not use on unsealed wood. This could cause  
the wood grain to rise. It is therefore recommended to test an isolated area  
of the surface to be cleaned before proceeding.  
Using the Steam Cleaner With the Hose  
To attach the hose to the main unit, align the end of the hose that has the two pins  
with the notches in the nozzle of the unit. Push the hose into the nozzle until it stops  
against the appliance. Turn in a clockwise direction until it locks in place.  
To attach the concentrator nozzle or the steam diffuser to the hose, follow the same  
instructions as above.  
CAUTION: Do not plug in the machine during filling. Use a grounded  
receptacle. Use only a heavy duty extension cord rated for 15 amps - Do  
not use an ordinary extension cord.  
IMPORTANT: Do NOT add cleaning solutions, scented perfumes, oils  
or any other chemicals to the water used in this appliance. Use regular  
water or distilled/purified water if the tap water in your area is very  
hard.  
Cleaning Cloth  
The cleaning cloth is  
used with the steam  
diffuser. Just slip it over  
the steam diffuser. This can be  
used to clean upholstery.  
4
7
 
OPERATING INSTRUCTIONS  
How To Assemble & Use  
OPERATING INSTRUCTIONS  
Attachments  
Concentrator Nozzle / Steam  
Diffuser  
CAUTION: Always ensure the unit is “UNPLUGGED” from the wall  
receptacle prior to filling or re-filling the water tank. Failure to follow these  
steps will cause the water tank to overfill.  
To attach the concentrator nozzle or  
the steam diffuser to the nozzle, align  
the end of the concentrator nozzle /  
steam diffuser that has the two pins  
with the notches in the nozzle of the  
unit. Push the attachment into the  
nozzle until it stops against the  
appliance. Turn in a clockwise  
Step 1: Before filling the steam cleaner, make sure that the unit is NOT plugged in.  
Step 2: Turn Safety Cap counter clockwise until removed.  
Step 3: Place funnel in the tank and add water. Do not overfill. Replace Safety  
Cap by turning clockwise - press down firmly to tighten.  
Heating time is approximately 5-6 minutes. Filling the boiler with hot water  
will shorten heat up time.  
Step 4: Plug the unit into a standard 120 volt wall receptacle. The power light will  
light up.  
Step 5: Allow approximately 5-6 minutes for water vapor to reach its working  
temperature and pressure.  
direction until it locks in place. (See  
illustration.) The attachment is now  
locked into position.  
Step 6: At the start, some water will come out from the nozzle. This is normal.  
Window Squeegee  
WARNING: Disconnect steam cleaner from wall outlet before refilling.  
It is time to refill your steam cleaner when there is no more steam coming out  
of the nozzle. Because the water tank is pressurized, use caution when  
opening to refill. Always let unit cool for 5 minutes before opening the safety  
cap. Depress the trigger button while you unscrew the safety cap  
counterclockwise.  
CAUTION: When cleaning outside windows, always avoid any sudden  
changes in temperature to prevent breakage or cracks.  
To attach the window squeegee to the steam diffuser, place the two hinges at the  
back of the window squeegee (see illustration) into the two open tabs that are at the  
back of the steam diffuser. Swing the window squeegee up against the bottom of the  
steam diffuser until the locking tab engages.  
CAUTION: When refilling the appliance while it is still hot, the first drops  
of water might bubble up. Use caution when opening the Safety Cap.  
Refilling With Water  
Step 1: Disconnect electrical power cord from wall outlet.  
Step 2: Press trigger button until all pressure has been  
released.  
Step 3: Wait for approximately 5 minutes before carefully  
unscrewing the safety cap.  
Step 4: Turn slowly a half turn and wait for the hissing  
noise created by residual steam to stop.  
Step 5: Unscrew the safety cap completely and allow  
to cool.  
Step 6: Slowly pour water using the measuring cup and  
the funnel into the boiler. DO NOT OVERFILL.  
Always leave approximately an inch between  
the top of the unit and the water level.  
To remove the window squeegee from the  
steam diffuser, just push your thumb against  
the locking tab on the window squeegee.  
Step 7: Screw safety cap back on the appliance and plug appliance back into wall  
outlet. Steam will start to be produced as before.  
WARNING: This appliance is under pressure. After every use, press  
trigger button until all pressure has been released before removing safety cap.  
6
5
 

Electro Voice Microphone 719KK User Manual
Electro Voice Portable Speaker Sb120a User Manual
Eton Weather Radio FR170 User Manual
Fisher Price Baby Toy B1836 User Manual
Fisher Price Crib W9443 User Manual
Freud Tools Router Router User Manual
FujiFilm Digital Camera 16421452 User Manual
GBC Cooktop type m6 User Manual
Gigabyte Computer Accessories GA 8GEM667 User Manual
Gitzo Camcorder Accessories GT2541 User Manual