TW-25S & TW-35S Installation Guide
Flush Mount Assembly
Flush Mount Complete assembly
Flush Mount Installation
Push assembled tweeter through cut out hole
Top Ring
Cut diameter: TW-25S=2” (50.8mm), TW-35S=3” (76.20mm)
Make sure that
the top ring and
bottom cup snap
when pushed
together
Fasten the panel
clamp down from
behind the panel.
Panel
Panel Clamp
Twist on nut
until the
Bottom Cup
tweeter is
secured
Angle Mount Assembly & Installation
Surface Mount Assembly & Installation
Earthquake has provided two (2)
mounting screws to be used in
the Angle and Surface options
Top Ring
Top Ring
Mounting screws
Panel
Bottom Cup
Bottom Cup
Panel
|
Eagle Electronics Marine GPS System 640C User Manual
Extron electronic Speaker SI 3CT LP User Manual
Freestyle Watch TIDE 30 User Manual
Frigidaire Washer FWS445RF User Manual
Frymaster Fryer EH1721 SERIES User Manual
Fujitsu Power Supply MB39A104 User Manual
Furuno Boating Equipment SC 50 User Manual
Furuno Telephone FS 5000 User Manual
Gitzo Camcorder Accessories GT1540G User Manual
Goodman Mfg Digital Camera G SHOT 3029TFT User Manual